-40%
Knife Maker's Edge Line Scriber, Edge Scribe, 2X72 Knife Maker's Center Scribe
$ 15.83
- Description
- Size Guide
Description
This is a New Knife Maker's Edge Line Scriber. The body of this scribe is made from 1" X 3" 1018 steel round bar stockand has a 13/16" flat milled lengthwise. The cross bar is made from 1/2" X 2-1/2" 1018 steel round bar stock and has a 7/16" flat milled lengthwise. The crossbar is held in place by 1/4-20 Thumb Screw. This screw is solid brass so it will not chew up the surface of the steel crossbar when tightened down. The tungsten carbide rod
is 1/8" (.125) diameter by a full 1-1/2" long solid carbide. This rod
has been professionally ground. One end of the carbide rod has a perfect very sharp 60 degree point and the back end has a very slight chamfer. The carbide rod is held in place in the cross bar by a solid brass thumb screw. There is about 1-1/2" of adjustment range and it will close down close to 1/16". This is a well made rugged scribe that can be used on the round or flat side of the body. Made in the USA in a Small New Hampshire Shop.