REPAIR SERVICE for western / fisher BOARD in a 4 Pin hand held plow controller

Description

THIS IS NOT A LISTING FOR THE BOARD OR PADS IN THE PICTURE.
picture is only for reference
This listing is
ONLY FOR REPAIRING OF THE BOARD
in the 4 pin PLUG Western handheld board controller that looks
like  the one in the picture.  (PADs in picture are only for reference !!)
TOTAL COST IS .00 PLUS 8 SHIPPING
The factory pads on these fail or gum up early !!
Before you decide if the board needs repair or a rebuild, open it up, and clean the contact areas on the board and the rubber parts under the pad with a qtip and a little alcohol. Then buff off the alcohol residue with a dry qtip. See if that changes things
The cords on almost all of these also crack where they leave the handle.
You need to send your controller or board to get THE BOARD repaired
I will bill you once THE BOARD is repaired. No need to advance pay !!
PLEASE CLEAN YOUR CONTROLLER some BEFORE SENDING IT
AGAIN: This is JUST TO REPLACE THE BAD PARTS YOUR BOARD
Corroded or burned board may not be able to be repaired and may be returned as is
1 year warranty only on the work that was done
Usual repair time is 1 day plus shipping time
I use priority mail